Chemical Feed Skids / Dry Polymer Feeders

• Polymer feed capacities of 10 to 2100 pounds per day (5 to 950 kg/day).
• Solution capacities of 10 to 80 GPM (40 to 300 lpm).
• Hopper capacity of 2.7 cu ft.
• Hopper screen traps polymer lumps.
• Hopper vibrator assures consistent polymer flow.
• Modular, compact, and reliable design accomodates your needs.  Ecologix can supply a complete system or only the components needed to complement your equipment.
• The POLYDUCTOR is a high energy eductor.  It is specifically designed for polymer service.  The Polyductor suction lifts, disperses, and hydrates the polymer.  It has a high suction air-flow capacity.  The high air flow causes the polymer to enter the Polyductor at very high velocity. This results in finer dispersion and better, faster hydration.  Its surfaces are continuously flushed to prevent polymer build-up.  
• Dilution water pressure range capacity of 40 to 100 psi (2.7 to 6.8 bar).
• ROTATING DISC FEEDER.  It reliably feeds the polymer and other difficult to handle materials.  The disc continuously vacuums itself clean to prevent build-up.  The feeder is enclosed.  A clear door panel allows the operator to see inside.  All components are within easy access.  

• AIR HEATER / DRYER.  It provides low humidity air to the hopper and the feeder enclosure.
• TEFLON CONVEYING TUBE.  The tube is made of translucent Teflon. It allows the operator to see the dry polymer flow.  It's non stick properties allow free flow even in high humidity.
• NON-STICK SURFACES.  Ecologix makes maximum utilization of surfaces which resist polymer sticking and are easy to clean.
• PROXIMITY SENSORS.  Sensors monitor the polymer level on the feeder disc.
• PLC control simplifies changing operating parameters and improves reliability.
• Can be used with other dry products such as Potassium Permanganate and clay.

The Polyductor is engineered specifically for polymers and other difficult to wet materials.

It generates high conveying air flow.    The design transport velocity is 3000 ft/min.  The high velocity scrubs the suction tube clean.  The tube is made of Teflon to prevent polymer sticking.  The Teflon is translucent for quick visual inspection.

High speed collision between the polymer granules and the water stream assures thorough dispersion and wetting. This results in faster hydration and minimizes the required aging time for maximum polyner activation.

The water jet scrubs the air of all dust particles.

Internal surfaces are continuously flushed to prevent build-up.

Polyductor will draw polymer up to 15 feet vertically and 30 feet

CAPACITIES:

            Dilution Water Flow:         10, 20, 40, 80 GPM.

            Polymer Feed Capacity:   3, 6, 12 lbs/min.

            Water pressure range:    40 to 100 psig.